Primer system that fights your corrosion battles for you.Awlgrip 545 is a two component epoxy primer system with corrosion and adhesion properties for steel, aluminum,wood, and fiberglass substrates above or below the waterline. The two part system consists of a base andconverter, and is used to seal filler primers and fairing work before applying topcoats.Key FeaturesExcellent corrosion and adhesion propertiesUse where high build and filling is requiredUsed to seal filler primersGives an ideal undercoat for all Awlgrip topcoatsPhysical DataType: Epoxy PolyamideFormulation: Top/Bottom epoxy primerComponents: 2VOC: 435 g/ltApplicationRecommended Application Method: Conventional or airless spray and brush/rollerNumber of coats recommended: 2-3Induction Time after Mixing: 15 MinutesRecommended Wet Film Thickness: 7-10 milsRecommended Dry Film Thickness: 2-3 milsApplication Temperature: minimum 13C (55F) maximum 41C (105F).Primer Needed: Ultra Build PrimerCoverage: 497 Sq. feet/gallonConverter: AwlGrip (D3001)Cleaner: T0006, T0002, ReducersDrying Times* (Hours)Drying @77FSprayBrushRollTo recoat1 hr.12-14 hr.12-14 hr.More informationFor detailed application instructions see the AwlGrip 545 anti-corrosive Data Sheet.NOTE: Manufacturer datasheets are subject to revision. Linked data sheets are believed to be accurate at the time of